Premium HD TV Antenna Booster Amplifier With 15 dB Gain And Ultra Low Noise
Premium HD TV Signal Amplifier With 15
dB Gain And Ultra Low Noise
This digital TV antenna amplifier will allow your TV antenna to pick up more local TV channels and enhance the clarity and reception of the broadcast TV channels available in the
area, very useful for rural or remote areas.
It works well with any indoor type non-powered or powered TV antenna and can pick up all UHF/VHF, digital ASTC and DVB-T TV signals over the air.
This TV antenna amplifier works best for weak TV signal areas and is subject to overdrive if used in areas with fairly strong TV signals.
This antenna amplifier is also needed when distributing TV signal through a splitter to multiple outlets in the house because splitters reduce the signal strength.
 |
Built With High 15-dB Gain
This indoor TV amplifier is built with 15-dB high gain from the internal booster used.
It improves the RF amplification
between the receiver and the antenna so that you can get an improved reception.
This indoor amplifier increases the TV reception range with stable and clear picture quality. Viewers can get more broadcast HD TV channels through using this amplifier than when using just the antenna alone.
 |
 |
Super Low Noise Circuitry
This TV signal amplifier adopts low-noise RF amplification circuitry to maximize the reception strength and provide pure TV signal free of interference.
The internal booster circuitry converts any low power, low frequency RF signal into higher frequency at higher power one but with super low noise, typically 1 dB only.
3-Minute Easy Setup
Its setup is a breeze to install in 2 to 3 minutes. No tools needed at all ! All connections are easy F-type coaxial
ports so everything screws right in.
Digital Amplification Technology
This booster enhances non-powered antenna using the latest digital amplifier
technology and also help eliminate the TV channel drop-outs due to long antenna cable runs or use of RF coax splitters.
 |
Easy Gain Control
The high/low dip switch on this amplifier allows users to select high gain or low gain
for optimal TV reception for over the air
channels.
This gain adjustment is handy for users to balance the signal level in installation. It boost the TV signal strength to eliminate channel drop-outs due to long cable runs or use of RF coax splitters.
 |
 |
Dual
Power Supply Option
This antenna mini amplifier can be powered from USB port or USB To AC
charger with DC 5V power supply. It is suitable for worldwide use for all 110V
to 240V setups.
 |
- This TV antenna signal booster helps improve the reception range and pick up more TV channels available over the air.
- Enhance any non-powered antenna using the latest amplifier technology.
- Boost the TV signal strength to eliminate channel drop-outs due to long cable runs or use of RF coax splitters.
- Great for use in locations with low signal reception such as rural or remote areas.
- A great solution for fixing the TV picture problems of noise, snowy picture or interference.
- Supports both digital and analog broadcast TV signals
- Works well with any indoor passive type non-powered TV antenna.
- This TV antenna amplifier works best for weak signal areas and is subject to overdrive if used in areas with fairly strong signals.
- The high/low dip switch on this amplifier allows users to select high gain or low gain for optimal TV reception for over the air channels.
- Maximum 15 dB gain output with super low noise 1 dB only.
- Powered from either USB port or using the USB To AC charger with DC 5V power supply.
- Suitable for worldwide use for all 110V to 240V setups.
- Input/Output Connector: Type "F"
-
RF Signal Gain:
- 17dB max for analog UHF/VHF
- 15dB max for digital ASTC/DVB-T
- Operation Frequency: 47-860MHz
- Output Impedance: 75 ohm for input/output
- Noise Figure: 1dB
- Standing Wave Ratio: <= 1.5
- Power Supply:
- USB 5V, 1A
- USB to DC 5V, 1A output
- TV antenna amplifier unit
- USB cable and USB to AC power adapter
- Coaxial antenna cable
- User manual